Charms DIY Guide

 

Step 1: Prepare Your Project

Pick the beads that you like. Begin by laying out the charms in a pattern at approximately 12". Make sure two side add a small bead. 

Step 2: Prepare String wire

Cutting stringing wire, both side add 5" of extra wire.( wire needs to be 17") Used an alligator clip close one end

Step 3: String Your Beads

Begin stringing beads onto the beading wire. Have fun!

 

Step 4: Prepare The Ending

Prepare 2 U-shape terminators , 4 crimp beads , 2 small rings and 2 large rings

 

Step 5: Finish The Ending

Stringing two crimp beads and then a U-shape terminators. Next, bring the stringing wire back through two crimp beads. Use needle nose plier to clamp the two crimp beads. (Other side, remove bead stopper, repeat the step before. )

 

Step 6: Clean Up

 

Snip excess wire with cutting plier as close into the bead as possible being careful not to cut the main stringing wire. 

 

Step 7: Clip on

Use needle nose plier to open the small ring and insert the large ring, on the other side,  repeat the same.

 

Congratulations! You have just completed your project!